Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
All buttons with odd
numbers behave during
disabling as
Module button 1
Module button 2
...
Module button 8
Disabling function 1
Disabling function 2
If a specific button function is to be
assigned during disabling to all or to
individual buttons, this parameter can be
used to select the desired button the
function of which will then be executed.
During disabling, all the buttons with an
odd button number behave like the one
configured here.
The desired functions can either
correspond to the function of an existing
button or they can be configured as
special disabling functions.
Visible only if "Behaviour during active
disabling = all buttons behave as" or
"Behaviour during active disabling =
individual buttons behave as"!
Reaction of pushbutton
sensor at the end of
disabling
No reaction
Reaction as button >>Y<<
when pressed
Reaction as button >>Y<<
when released
Reaction as disabling
function 1 when pressed
Reaction as disabling
function 1 when released
Reaction as disabling
function 2 when pressed
Reaction as disabling
function 2 when released
Internal scene recall
scene 1
Internal scene recall
scene 2
Internal scene recall
scene 3
Internal scene recall
scene 4
Internal scene recall
scene 5
Internal scene recall
scene 6
Internal scene recall
scene 7
Internal scene recall
scene 8
Besides disabling of rocker and button
functions, the pushbutton sensor can
also trigger a special function
immediately at the end of disabling.
This function can...
correspond to the function assigned to
any of the buttons in the non-disabled
state ("Reaction as button >>X<< …"),
be defined on the following parameter
pages
("Reaction as disabling function …"),
recall a scene stored internally in the
pushbutton sensor
("Internal scene recall …").
Page 339 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English