Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
Internal scene recall
scene 2
Internal scene recall
scene 3
Internal scene recall
scene 4
Internal scene recall
scene 5
Internal scene recall
scene 6
Internal scene recall
scene 7
Internal scene recall
scene 8
Button >>X<< Module button 1
Module button 2
…
Module button 8
If the pushbutton sensor is to perform
the function of a specific button at the
beginning of the disabling state, this
button will be selected here.
Visible only if "Reaction of pushbutton
sensor at the beginning of the disabling
function = Reaction as button >>X<< on
pressing / releasing"!
Behaviour during active
disabling
All buttons without
function
All buttons behave as
Individual buttons without
function
Individual buttons behave
as
While disabling is active...
all buttons or only individually selected
buttons can be disabled
("… no function"),
all buttons or only individually selected
buttons can be restricted to a specific
function ("… behave as"). In this case,
the ETS shows further parameters.
All buttons with even
numbers behave during
disabling as
Module button 1
Module button 2
...
Module button 8
Disabling function 1
Disabling function 2
If a specific button function is to be
assigned during disabling to all or to
individual buttons, this parameter can be
used to select the desired button the
function of which will then be executed.
During disabling, all the buttons with an
even button number behave like the one
configured here.
The desired functions can either
correspond to the function of an existing
button or they can be configured as
special disabling functions.
Visible only if "Behaviour during active
disabling = all buttons behave as" or
"Behaviour during active disabling =
individual buttons behave as"!
Page 338 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English