Art. No. SC 1000 KNX
i Telegrams of the timer are transmitted to the bus for the switching times via the objects of
the KNX channels. The timer commands do not influence the individually set button/rocker
commands (transmission values) of the KNX channels, however.
Example "value transmitter": The channel is set to the value "50" (button/rocker command)
in the ETS or by local operation on the device. The timer executes a switching command
with the value "75" and then transmits a telegram with this value via the channel object.
The actual transmission value of the channel ("50") is not affected by this. In the case of a
subsequent operation of the channel, the value "50" is transmitted to the bus.
Page 228 of 347
Software "Smart Control 501511"
Functional description
To Next Page
Loading...
