Art. No. SC 1000 KNX
Icon 9: Holiday
Icon 10: Warning
Icon 11: Alarm
Icon 12: Cooling
Icon 13: DCM
Icon 14: Door
Icon 15: Window
Icon 16: Weather
Icon 17: Messages
Icon 18: Outdoors
Icon 19: Indoors
Icon 20: Setpoint
h Display -> channels 1...30 -> channel X (X = 1...30)
Function unit no function unit
Function unit 1: Name of
function unit 1
Function unit 2: Name of
function unit 2
Function unit 3: Name of
function unit 3
Function unit 4: Name of
function unit 4
Function unit 5: Name of
function unit 5
Function unit 6: Name of
function unit 6
Function unit 7: Name of
function unit 7
Function unit 8: Name of
function unit 8
Each controllable KNX channel must be
allocated to a function unit (light,
shading, heating, ...). Up to 8 function
units are available for assignment. The
first 4 function units are defined as
follows: Function unit 1 = "Switching",
Function unit 2 = "Venetian blind",
Function unit 3 = "Temperature",
Function unit 4 = "Scenes". The function
units 5...8 can be enabled optionally in
the parameter node "Display -> Function
unit".
It is possible to allocate a channel to a
function unit which is not visible itself on
the function page, because it was not
created in the configuration of the
function units in the parameter node
"Display -> Function units". In this case,
the KNX channel concerned cannot be
accessed via the function page! It is
generally recommendable to assign
KNX channels only to function units that
are also available in the function unit
configuration.
The standard setting of this parameter
depends on the set function of the
channel.
Room no room
Room 1: Name of room 1
...
Room 8: Name of room 8
Each KNX channel must be allocated to
a room (area of operation). Channels
can be operated and visualized room-
oriented via the room page. A maximum
of 8 rooms are available for assignment.
The number of rooms (1...8) is
configured in the parameter node
"Display -> Rooms".
It is possible to allocate a channel to a
room which is not visible itself on the
room page, because it was not created
in the configuration of the rooms in the
parameter node "Display -> Rooms". In
this case, the KNX channel concerned
cannot be accessed via the room page!
It is generally recommendable to assign
KNX channels only to rooms that are
also available in the room configuration.
Page 253 of 347
Software "Smart Control 501511"
Parameters