Jung Smart Control SC 1000 KNX - Page 269

Art. No. SC 1000 KNX
If the setting is "No", a long operation of
the display area shows no response.
This parameter is only visible when the
"surface evaluation" is configured to
"Button function (single surface)".
Minimum value -671088.64...
0.0
...670760.96
This parameter scales the bar graph in
the display (value feedback in graphic
form) by defining the minimum
displayable value (no deflection of the
bar graph). Furthermore, this parameter
predefines the minimum presettable
value via the keyboard provided that a
keyboard is used for presetting the
value.
Maximum value -671088.64...
100024.32
...670760.96
This parameter scales the bar graph in
the display (value feedback in graphic
form) by defining the maximum
displayable value (full deflection of the
bar graph). Furthermore, this parameter
predefines the maximum presettable
value via the keyboard provided that a
keyboard is used for presetting the
value.
Amplification -671088.64...
1.0
...670760.96
Before a value is transmitted to the bus
via the object during an operation, the
device calculates the value to be
transmitted based on the gain factor and
value offset. The same applies to the
value display. The value received from
the bus via the feedback object is
influenced - in the opposite way than
during transmission - by the gain factor
and value offset and only displayed
afterwards.
This parameter specifies the gain of the
value. The gain can be positive as well
as negative.
Offset -1215752191...
0
...1215752191
Before a value is transmitted to the bus
via the object during an operation, the
device calculates the value to be
transmitted based on the gain factor and
value offset. The same applies to the
value display. The value received from
the bus via the feedback object is
influenced - in the opposite way than
during transmission - by the gain factor
and value offset and only displayed
afterwards.
This parameter defines the offset (shift)
of the value. The offset can be positive
as well as negative.
Page 269 of 347
Software "Smart Control 501511"
Parameters