Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
control is active.
h Display -> Timer
Overwriting timer
parameter
Yes
No
For the switching times preset in the
ETS to be correctly transferred to the
device during a programming operation,
the parameter "Overwrite timer
parameter" must be set to "Yes". Before
putting into operation for the first time,
this parameter should be set to "Yes".
Otherwise, the switching times preset in
the ETS are not transferred to the
device.
If the parameter is configured to "Yes",
the switching times changed directly on
the device via the display pages are
always overwritten during programming
operations. If the setting is "No", the last
configured switching times set on the
device remain unchanged during an
ETS programming operation.
This parameter is only visible if a timer is
present.
Geographic longitude of
the location
(-180.0°...180.0°)
-180.0...9.5...180.0 The geographic longitude of the location
where the device is installed is entered
here. The default is the coordinates of
the city of Kassel.
Geographic latitude of
the location
(-180.0°...180.0°)
-180.0...51.31...180.0 The geographic latitude of the location
where the device is installed is entered
here. The default is the coordinates of
the city of Kassel.
Time zone UTC-12h...UTC+1h...
UTC+14h
The time zone of the location/country
where the device is located is entered
here. The default is the coordinates of
the city of Kassel, Germany.
Automatic summer/
winter time changeover
Yes
No
Here, it is specified whether the timer
works with an automatic change-over
from summer to winter time. In the "Yes"
setting, the time is changed over
automatically. In the "No" setting, the
time must be adjusted manually.
h Display -> Timer -> Switching time 1
Switching time 1 not active
active
The device has an integrated weekly
timer and can be configured using the
ETS. The timer has up to 8 switching
times, which directly affect the
configured KNX channels (1...30) in the
device.
Page 279 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English