Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
2 fan levels
3 fan levels
4 fan levels
5 fan levels
6 fan levels
7 fan levels
8 fan levels
fan level outputs, for which the actually
used number of levels (1...8) is set using
this parameter.
Fan level switch-over
via
Switching objects (8 x 1
Bit)
Value object (1 byte)
Depending on the data format of the
objects of the controlled actuators, the
change-over between the fan levels can
either take place via up to 8 separate 1-
bit objects or, alternatively, via one 1-
byte object. The "Fan level change-over
via" parameter defines the data format
of the controller. With the 1-bit objects,
each fan level discreetly receives its
own object. With the 1-byte object, the
active fan level is expressed by a value
("0" = Fan OFF / "1" = Level 1 / "2" =
Level 2 / "3" = Level 3 / etc.).
Fan threshold value
OFF
-> Level 1,
* 1 %
1...100 In automatic operation, the command
value of the controller is used internally
in the device for automatic control of the
fan levels. As a transition between the
levels, there are threshold values,
defined according to the command value
of the controller, which can be set here.
If the command value exceeds the
threshold value of a level, the
appropriate level is activated. If the
command value sinks below a threshold
value, minus the configured hysteresis,
then the change-over takes place into
the next lowest fan level.
Fan level 1 threshold
value -> Level 2,
* 1 %
1...30...100
Fan level 2 threshold
value -> Level 3,
* 1 %
1...60...100
Fan level 3 threshold
value -> Level 4,
* 1 %
1...90...100
Fan level 5 threshold
value -> Level 6,
* 1 %
1...100
Fan level 6 threshold
value -> Level 7,
* 1 %
1...100
Fan level 7 threshold
value -> Level 8,
* 1 %
1...100
1...3...50
Page 289 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English