Jung Smart Control SC 1000 KNX - Page 308

Art. No. SC 1000 KNX
contain decimal places are rounded to
the nearest whole number, of course.
The ETS parameters "switching value",
"1-byte switching value" and "2-byte
switching value" are always visible. The
function of the allocated KNX channel
defines which of these parameters is
enabled In the channel functions "scene
extension" and "operating mode
switchover internal" none of the
aforementioned parameters are
enabled. In these cases, the channel
command of the timer is specified
directly by the configuration of the KNX
channel.
Page 308 of 347
Software "Smart Control 501511"
Parameters