Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
This parameter defines the scene
number which is to be transmitted to the
bus after a scene recall or during
storage of a scene.
Visible only if "Full-surface operation =
enabled"!
h Push-button extension module -> Button configuration -> Operation concept of extension
module -> Module rocker switch 2...4 like module rocker switch 1!
h Push-button extension module -> Button configuration -> Operation concept of extension
module -> Module button 1
Function No function
Switching
Dimming
Venetian blind
Value transmitter 1-byte
2-byte value transmitter
Scene extension
2-channel operation
Operating mode
switchover, internal
Setpoint shift, internal
This parameter defines the basic
function of the button.
Depending on this setting, the ETS
displays different communication objects
and parameters for this button.
The following parameters are only visible for the push-button function "Switching"...
Command on pressing
the button
No function
ON
OFF
TOGGLE
Depending on the "button arrangement"
parameter, these parameters define the
reaction that takes place when the
button is pressed or released.
Command on releasing
the button
No function
ON
OFF
TOGGLE
The following parameters are only visible for the push-button function "Dimming"...
Command on pressing
the button
No reaction
Brighter (ON)
Darker (OFF)
Brighter / darker
(TOGGLE)
Brighter (TOGGLE)
Darker (TOGGLE)
This parameter defines the reaction
when the button is pressed.
If the push button sensor is to toggle on
a brief press, the corresponding
switching objects of other sensors with
the same function must be linked with
one another. In the "Brighter/darker
(TOGGLE)" setting, the dimming objects
must be interlinked as well so that the
push button sensor can send the correct
telegram on the next button-press.
Time between switching
and dimming
(100...50000 x 1 ms)
100...400...50000 This parameter defines how long the
button must be pressed for the push
button sensor to transmit a dimming
Page 325 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English