Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
The following parameters are only visible for the push-button function "Venetian Blind"...
Command on pressing
the button
DOWN
UP
TOGGLE
This parameter defines the running
direction of a drive after a button-press.
If the setting is "TOGGLE", the direction
is changed after each long time
command. If several push buttons are to
control the same drive, the long time
objects of the push buttons must be
interlinked for a correct change of the
running direction.
Operation concept short – long – short
long – short
short – long
long – short or short
For Venetian blind control, four different
operation concepts can be selected. For
these concepts, the ETS shows further
parameters.
Time between short-
time and long-time
command
(1...3000 x 100 ms)
1...4...3000 This parameter sets the time after which
the long time operation will be evaluated
on pressing the top (or left-hand) button
of the rocker. This parameter is not
visible with "Operation concept = long –
short"!
Slat adjusting time
(0…3000 x 100 ms)
0...5...3000 Time during which a transmitted long
time telegram can be terminated by
releasing the top (or left-hand) button of
the rocker (short time). This function
serves to adjust the slats of a blind. This
parameter is not visible with "Operation
concept = long – short"!
The following parameters are only visible for the push-button function "Value transmitter 1
byte"...
Function Value transmitter 0...255
Value transmitter 0…100 %
A button configured as "Value
transmitter 1 byte" permits selecting
whether the values to be transmitted are
interpreted as integers from 0 to 255 or
as a percentage from 0 % to 100 %. The
following parameters and their settings
depend on this distinction.
Value (0...255) 0...255 This parameter defines the object value
when the button is pressed. Visible only
if "Function = 0...255"!
Value (0...100 %) 0...100 This parameter defines the object value
when the button is pressed. Visible only
Page 327 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English