Art. No. SC 1000 KNX
Temperature value of
the button for channel 1
(2)
(0...40 °C)
0...40 This parameter defines the temperature
value transmitted to the bus when the
button is pressed. Visible only if
"Function channel 1 (2) = Temperature
value transmitter (2 bytes)"!
Time between channel
1 and channel 2
(1...255 x 100 ms)
0...30...255 Depending on the selected operation
concept, this parameter defines the
interval at which the push button
transmits the telegram for channel 1 and
the telegram for channel 2 when the
button is pressed.
The following parameters are only visible for the push-button function "Operating mode
switchover, internal"...
Button function No function
Operating mode
switch-over
Presence button
The "Operating mode switchover,
internal" push-button function can be
used to control the internal room
temperature controller. If this push-
button function is used, it is possible to
change over the operating mode by
pressing the button. In the controller
operating mode, a distinction is made
between two functions, specified by this
parameter. On the one hand, the
operating mode (Comfort, Standby,
Night, Frost/heat protection) can be
changed over and influenced
("Operating mode change-over" setting).
On the other hand it is possible to
activate the Presence function
("Presence button" setting). The
Presence function allows activation of
Comfort mode or a comfort extension on
the internal controller.
Operating mode button
actuation
Comfort mode
Standby mode
Night operation
Frost/heat protection mode
Comfort mode ->
Standby mode
Comfort mode ->
Night operation
Standby mode ->
Night operation
Comfort mode ->
Here, there is a specification of which
operating mode is activated when a
button is pressed. It is possible to
change over between various operating
modes.
Only visible if "Button function =
Operating mode change-over".
Page 333 of 347
Software "Smart Control 501511"
Parameters
To Next Page
Loading...
Need help?
General
