Art. No. SC 1000 KNX
concerned during the recall of the
scene. The scene output is deactivated
for this scene.
Scene 1
Transmit delay
(1 … 1200 * 100 ms)
(0 = deactivated)
0...1200 When the device sends the telegrams to
the various scene outputs, it can insert a
presettable waiting time of 2 min. max.
before each telegram. The bus load can
be reduced by this. In this way, it is
possible to have certain illumination
switched on only after the shutters are
really closed.
If no delay is selected ("0" setting), the
device sends the output telegrams with
maximum speed. With this setting it may
happen in some cases that the telegram
sequence is not compatible with output
numbering.
Scenes 2 … 8 see
scene 1!
h Scene -> Scene output 2...8 like Scene output 1!
Page 344 of 347
Software "Smart Control 501511"
Parameters
To Next Page
Loading...
Need help?
General
