Art. No. SC 1000 KNX
configured using the ETS and via a special timer display page, has up to 8 switching times. The
switching times affect KNX channels (1...30) configured in the device and can handle the data
formats switching (1 bit), Value 1 byte (incl. brightness value and position setting) and
Value 2 byte and similarly transmit telegrams to the bus.
Different settings can be made available to the Administrator via a password-protected system
page (setting of time and date, password assignment, activation of KNX programming mode).
A bus coupling unit is already permanently integrated in the device, allowing the device to be
connected directly to the bus cable during commissioning.
The Smart Control needs an external DC power supply for supplying the device electronics (see
chapter 3. Technical data). It is not possible to use the unchoked output of KNX power supplies
as device power supply! The power supply must be provided by an additional device (e.g. RMD
or UP DC power supply) (see accessories).
Page 6 of 347
Product definition
To Next Page
Loading...
Need help?
General
