Art. No. SC 1000 KNX
i Dimmer actuators normally transmit brightness values as feedback when the dimming
processes have been completed, i.e. when dimmed or started brightness values have been
set valid. For this reason, status indications of the channel element concerned do not
normally change during a press of the sensor surface, but only when the buttons are
released and the dimming processes are stopped. By contrast, a displayed status value
can already change even during an operation if the dimmer actuator has set a minimum or
maximum brightness or cannot pass through the entire brightness range due to disabling
functions.
The feedback of a brightness value is returned with a delay after switching on or off based
on the dimming speed set in the dimmer actuator. As a result, the status indications of the
channel element update themselves with a slight delay after releasing the sensor surface.
Page 85 of 347
Software "Smart Control 501511"
Functional description
To Next Page
Loading...
Need help?
General
