Juniper ACX7348 - Perform Initial Software Configuration for ACX7348 Routers

(Connued)
Electrical Characteriscs of LMR400 Cable
Insulaon Resistance > 5000 MΩ
Cabling Guidelines
Follow these guidelines when you install cables:
• Examine the cable end points and connectors for any bends or damage.
• Check the electrical connuity of the cable for both inner and outer conductors.
• Check for any electrical short in cables.
• Inspect the cable outer sheath for any damage.
Perform Inial Soware Conguraon for ACX7348
Routers
You can easily customize the factory-default conguraon with just a few commands. Inially, you’ll
need to make changes through the console port. Aer you congure the management port, you can
access the ACX7348 using SSH and make addional conguraon changes. You can always revert to the
factory-default conguraon whenever you want.
Have the following informaon ready before you begin customizing the router:
• Hostname
• Root authencaon password
• Management port IP address
• Default gateway IP address
• IP address and prex length of remote prexes
• (Oponal) SNMP read community, locaon, and contact informaon
1. Verify that the following default serial port sengs are congured on your laptop or desktop PC:
93