Juniper AP32 - Page 13

Table 2: Specicaons for AP32 (Connued)
Parameter Descripon
External antennas (AP32E) The AP does not support an antenna if its gain exceeds the values listed here:
• Omnidireconal antennas
• 2.4-GHz antenna—4 dBi peak gain
• 5-GHz antenna—6 dBi peak gain
• Direconal antennas
• 2.4-GHz antenna—8 dBi peak gain
•
5-GHz antenna—10 dBi peak gain
Bluetooth Omnidireconal Bluetooth antenna that supports superbeacon mode with iBeacon
and Eddystone
Power opons 802.3at (PoE+) or 802.3af (PoE)
Radio frequency (RF)
• 5-GHz radio—Supports 4x4:4SS 802.11ax MU-MIMO and SU-MIMO
• 2.4-GHz radio—Supports 2x2:2SS 802.11ax MU-MIMO and SU-MIMO
• 2.4-GHz or 5-GHz scanning radio
• 2.4-GHz Bluetooth® Low Energy (BLE) with omnidireconal antenna
Maximum PHY rate
(maximum transmit rate at
the physical layer)
• Total maximum PHY rate—2975 Mbps
• 5 GHz—2400 Mbps
• 2.4 GHz—575 Mbps
Maximum devices
supported on each radio
512
8