Juniper AP32 User Manual

AP32 Power Requirements
The AP32 requires 802.3at (PoE+) power. The AP32 requests 19.5-W power to provide wireless
funconality. However, the AP32 is capable of running on 802.3af (PoE) power with reduced
funconality as described below:
• The 5-GHz radio operates in 2x2 mode instead of 4x4 mode.
• The Eth0+PoE port operates at a maximum speed of 1 Gbps.
• The Eth1 port is disabled.
You can use any of the following opons to power on the AP:
• Power over Ethernet plus (PoE+) from an Ethernet switch
We recommend that you use an Ethernet cable with a maximum length of 100 m to connect the
access point (AP) to the switch port.
If you use an Ethernet cable that is longer than 100 m by placing an Ethernet PoE+ extender in the
path, the AP might power up, but the Ethernet link does not transmit data across such a long cable.
You might see the status LED blink yellow twice. This LED behavior indicates that the AP is unable to
receive data from the switch.
• PoE injector
9

Juniper AP32 Specifications

General

Brand	Juniper
Model	AP32
Category	Wireless Access Point
Language	English