Juniper AP32 - Mount an Access Point on a 1;2-Inch Threaded Rod

Figure 23: Aach the APBR-U Mounng Bracket to the ADPR-ADP-WS15 Adapter
3. Posion the AP such that the keyholes of the mounng bracket engage with the shoulder screws on
the AP. Slide and lock the AP in place.
Figure 24: Aach the AP to a 1.5-Inch T-Bar
Mount an Access Point on a 1/2-Inch Threaded Rod
To mount an access point (AP) on a 1/2-in. threaded rod, you'll need to use the APBR-ADP-T12 bracket
adapter and the universal mounng bracket APBR-U.
1. Aach the APBR-ADP-T12 bracket adapter to the APBR-U mounng bracket. Rotate the bracket
unl you hear a disnct click, which indicates that the bracket is locked in place.
31