Juniper AP32 - Universal Mounting Bracket (APBR-U) for Juniper Access Points

Table 3: Mounng Brackets for AP32 (Connued)
Part Number Descripon
APBR-ADP-RT15 Bracket adapter for mounng the AP on a recessed
15/16-in. T-bar
APBR-ADP-WS15 Bracket adapter for mounng the AP on a recessed
1.5-in. T-bar
APBR-AP-T12 Bracket adapter for mounng the AP on a 1/2-in.
threaded rod
NOTE: Juniper APs ship with the universal bracket APBR-U. If you need other brackets, you must
order them separately.
Universal Mounng Bracket (APBR-U) for Juniper Access Points
You use the universal mounng bracket APBR-U for all types of mounng opons—for example, on a
wall, a ceiling, or a juncon box. Figure 3 on page 18 shows the APBR-U. You'll need to use the
numbered holes to insert screws when mounng the AP on a juncon box. The numbered holes that
you use vary based on the type of juncon box.
17