Juniper AP32 - Supported Mounting Brackets for AP32

Mount an Access Point on a 1/2-Inch Threaded Rod | 31
Mount an AP32, AP33, AP41, or AP43 Access Point on a 5/8-Inch Threaded Rod | 34
Mount an AP32, AP33, AP41, or AP43 Access Point on a 16-mm Threaded Rod | 35
This topic provides the various mounng opons for the AP32. You can mount the AP on a wall, ceiling
or juncon box. The AP ships with a universal mounng bracket that you can use for all mounng
opons. To mount the AP on a ceiling, you'll need to order an addional adapter based on the type of
ceiling.
NOTE: We recommend that you claim your AP before you mount it. The claim code is located on
the rear of the AP and it might be dicult to access the claim code aer you mount the AP. For
informaon about claiming an AP, see "Claim a Juniper Access Point" on page 11.
Supported Mounng Brackets for AP32
Table 3 on page 16 lists the brackets available for the AP32.
Table 3:
Mounng Brackets for AP32
Part Number Descripon
Mounng Brackets
APBR-U Universal bracket for T-bar and drywall mounng
APBR-T58 Bracket for mounng the AP on a 5/8-in. threaded rod
APBR-M16 Bracket for mounng the AP on a 16-mm threaded rod
Bracket Adapters
APBR-ADP-CR9 Bracket adapter for mounng the AP on a recessed
9/16-in. T-bar or channel rail
16