Juniper AP32 - Page 4

Mount an Access Point on a 1/2-Inch Threaded Rod | 31
Mount an AP32, AP33, AP41, or AP43 Access Point on a 5/8-Inch Threaded Rod | 34
Mount an AP32, AP33, AP41, or AP43 Access Point on a 16-mm Threaded Rod | 35
Connect an AP32 to the Network and Power It On | 37
Rename a Juniper Access Point in the Mist Portal | 38
Assign an Access Point to a Site | 40
Release an Access Point from an Organizaon | 40
Upgrade the Firmware on a Juniper Access Point | 41
Check for AP Firmware Updates | 41
Upgrade the Firmware on an AP Manually | 42
Reset an Access Point to the Factory-Default Conguraon | 43
4
Troubleshoot
Troubleshoot a Juniper Access Point | 46
Status LED Blink Paerns | 46
Troubleshoot AP Claiming Issues | 57
Troubleshoot Access Point Disconnecon Issues | 58
Contact Customer Support | 71
iv