Juniper AP32 User Manual

Table 12: Troubleshoot AP Disconnecon Issues (Connued)
LED Color Blink Paern Issue Steps to Troubleshoot
Blinking yellow four mes No default gateway IP
address found in the
DHCP lease or stac
conguraon.
1. Check the DHCP pool
conguraon to see
whether the default
gateway is congured.
2. If you've congured a
stac IP address for
the AP, check whether
the default gateway is
congured correctly.
If the default gateway
is not congured
correctly, follow these
steps:
a. Power o the AP
by shung down
the PoE on the
switch port to
which the AP is
connected.
Alternavely, you
can remove the
physical cable that
provides power to
the AP.
b. Correct the
conguraon on
the switch port.
c. Reset the AP to the
factory-default
conguraon. See
"Reset an Access
Point to the
Factory-Default
Conguraon" on
page 43.
64

Juniper AP32 Specifications

General

Brand	Juniper
Model	AP32
Category	Wireless Access Point
Language	English