98 Chapter 7 Learn Geode Connect for Android
Geode GNS3 Real-Time Sub-Meter GPS Receiver
NTRIP Configuration
On the NTRIP
Configuration screen you
can set up NTRIP with
your Geode. Enter the
information supplied by
your NTRIP service provider,
including the caster IP
address, port, username,
and password.
Note: NTRIP settings
are stored in the Geode
Connect app, not in the
Geode receiver.
As stated in 2.3.2 NTRIP Differential Correction on page
11, NTRIP is a useful protocol for precise correction
of real-time positioning solutions. The Geode is able to
calculate an RTK float position. NTRIP services do require
an internet or cell data connection (via your mobile device)
and usually involve either a free or paid subscription to the
service.
If you have a subscription to an NTRIP service, Geode
Connect will allow you to configure the Geode to use that
service.
Note: Changes must be saved in order for them to remain
from screen to screen. If the save icon in the lower right
corner of the screen is orange, this means there has been a
change that needs to be saved. Tap the save icon to save
changes .
To Next Page
Loading...
Need help?
General