Chapter 5 Learn Geode Connect for iPad and iPhone 55
Owner's Manual
Configure NTRIP
This page is where you
enter the information
supplied by your NTRIP
service provider, including
the caster IP address, port,
username, and password.
Note: NTRIP settings
are stored in the Geode
Connect app, not in the
Geode receiver.
As stated in 2.3.2 NTRIP
Differential Correction
on page 11, NTRIP is a
useful protocol for precise
correction of real-time
positioning solutions.
The Geode is able to calculate an RTK float position with
decimeter-level accuracy. NTRIP services do require an
internet or cell data connection (via your mobile device)
and usually involve either a free or paid subscription to the
service.
If you have a subscription to an NTRIP service, Geode
Connect will allow you to configure the Geode to use that
service.
Note: Changes must be saved in order for them to remain
from screen to screen. To save changes, tap Save in the
upper right corner before you leave this screen.
To establish an NTRIP connection:
1. Make sure that the iPhone or iPad you are using to host
Geode Connect has a data connection.
2. Enter the identifying information supplied by your
NTRIP service provider.
To Next Page
Loading...
Need help?
General