84 Chapter 7 Learn Geode Connect for Android
Geode GNS3 Real-Time Sub-Meter GPS Receiver
4. Place the Geode in one stationary position. Do not move
it.
5. Open your mapping or data-collection app.
6. Holding your phone or tablet, walk five to ten paces out
and then walk in a circle around the Geode.
If the position in the data-collection app does not change
significantly (remember, the Geode is just sitting there), the
app is drawing its data from the Geode. You can continue to
use the app and the Geode without any worries.
If the position moves in a circle, the app is drawing its data
from your Android device’s internal GPS receiver. Return
to page 81 and make sure all mock location provider
settings have been properly configured.
Two-Person Test:
One person holds the Geode, and the other person holds
the Android device.
1. Connect the Geode to your Android device via
Bluetooth wireless technology in Geode Connect.
2. Verify that Geode Connect has been set as the mock
location provider.
3. Leave Geode Connect open.
4. Open your mapping or data-collection app.
5. The person holding the Android device remains
stationary.
6. The person holding the Geode walks five to ten paces
out and then walks in a circle around the person holding
the Android device.
If the position moves in a circle, the app is drawing its
data from the Geode and the mock location provider is
functioning as it should.
To Next Page
Loading...
Need help?
General