• DR Pri— Designated router priority value
• ControlPktCount In|Out—PIM messages received on and sent from this interface
• Hello—Total number of hello messages
• JoinPrune—Total number of join and prune messages
• Assert—Total number of assert messages
• Example 1
host1# show ip pim interface
PIM Interface Table
Interface Addr Interface State Ver Mode Nbr Hello J/P DR DR Addr JoinFilter
Count Intvl Intvl Pri
101.0.0.1 ATM2/0.100 Up 2 Sparse 1 30 150 5 101.0.0.2 -
102.0.0.1 ATM2/0.101 Up 2 Sparse 1 30 100 2 102.0.0.2 silver
103.0.0.1 ATM3/0.102 Up 2 Sparse 1 30 100 2 103.0.0.1 gold
• Example 2
host1#show ip pim interface summary
PIM Interface Summary
SM: 0, 0 enabled, 0 disabled
DM: 0, 0 enabled, 0 disabled
SM/DM: 1, 0 enabled, 1 disabled
• Example 3
host1#show ip pim interface count
PIM Interface Count
Interface Addr Interface Name ControlPktCount In|Out
Hello JoinPrune Assert
192.32.10.20 ATM3/0.20 0 0 0
0 0 0
• See show ip pim interface.
show ip pim neighbor
• Use to display information about PIM neighbors that the router discovered.
• Provide an interface type and specifier (such as atm 3/0) to display information about
that interface only. For details about interface types and specifiers, see Interface Types
and Specifiers in JunosE Command Reference Guide.
• Field descriptions
• Neighbor Addr—IP address of the neighbor
• Interface Name—Type and specifier of the interface to which the neighbor connects.
For details about interface types and specifiers, see Interface Types and Specifiers
in JunosE Command Reference Guide.
• Uptime—Time since the router discovered this neighbor in days hours:minutes:seconds
format
Copyright © 2010, Juniper Networks, Inc.114
JunosE 11.2.x Multicast Routing Configuration Guide
To Next Page
Loading...