RPF Route: 121.0.0.0/255.0.0.0 IIF: 107.0.8.4 UpNbr: 107.0.4.8
Pruned Oifs:
Address: 108.0.8.5 IfId: 95
Pruned due to assert
Pruned time remaining 133
• See show ip pim dense-mode sg-state.
show ip pim interface
• Use to display information about PIM interfaces.
• Specify no keywords or variables to view information about all PIM interfaces.
• Provide an interface type and specifier (such as atm 3/0) to display information about
that interface only. For details about interface types and specifiers, see Interface Types
and Specifiers in JunosE Command Reference Guide.
• Specify the summary keyword to view the number of configured, enabled, and disabled
PIM dense mode, PIM sparse mode, and PIM sparse-dense mode interfaces.
• Specify the count keyword to view the number of multicast packets that the interface
has sent and received.
• Field descriptions
• Interface Addr—IP address of the interface
• Interface Name—Type and specifier of the interface. For details about interface types
and specifiers, see Interface Types and Specifiers in JunosE Command Reference
Guide.
• Ver—Version of PIM running on this interface
• Mode—PIM mode running on this interface: Sparse, Dense, or SparseDense
• Nbr Count—Number of neighbors connected to this interface
• Hello Intvl—Time interval, in seconds, at which the interface sends hello messages
to neighbors
• J/P Interval—Time interval, in seconds, at which the interface sends the join/prune
messages
• DR Addr—Address of the designated router
• SM—Number of PIM sparse mode interfaces
• DM—Number of PIM dense mode interfaces
• SM/DM—Number of PIM sparse-dense mode interfaces
• enabled—Number of interfaces administratively enabled
• disabled—Number of interfaces administratively disabled
113Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Configuring PIM for IPv4 Multicast
To Next Page
Loading...
Need help?
General
