Juniper JUNOSE 11.2.X MULTICAST ROUTING

• Example 3—Displays a summary of data MDT senders
host1:PE1#show ip pim data-mdt senders summary
VRF S/R C-Group C-Source P-Group P-Source MTI
---- ------- --------- ----------- --------- -------- ---------------
PE11 Sender 225.1.1.1 10.11.0.100 235.0.1.1 1.1.1.1 TUNNEL gre:mvpn-dynamic-1
PE12 Sender 225.1.1.1 10.12.0.100 235.0.1.2 1.1.1.1 TUNNEL gre:mvpn-dynamic-2
Counts: 2 senders, 0 receivers, total 3.
• Example 4—Displays the number of data MDT senders and receivers
host1:PE1#show ip pim data-mdt count
Counts: 2 senders, 1 receivers, total 3.
• See show ip pim data-mdt.
show ip pim dense-mode sg-state
• Use to display information for each (Source, Group) pair for PIM dense mode.
• Field descriptions
• (Source, Group) pair—IP addresses of multicast source and group
• EntryExpires—Time until the (S,G) pair entry expires
• RPF Route—Reverse-path forwarding route
• IIF—IP address of incoming interface
• UpNbr—IP address of upstream neighbor
• Pruned Oifs—Outgoing interfaces that have been pruned
• Address—IP address of outgoing interface
• IfId—Index of the interface
• Pruned due to—Reason for prune: assert or explicit prune
• Pruned time remaining—Time in seconds until the prune expires
• Example
host1:8#show ip pim dense-mode sg-state
PIM DM route table and pruned oif information
<122.0.0.1, 224.0.1.39> EntryExpires: 99
RPF Route: 122.0.0.0/255.0.0.0 IIF: 107.0.8.4 UpNbr: 107.0.4.8
Pruned Oifs:
Address: 108.0.8.5 IfId: 95
Pruned due to assert
Pruned time remaining 129
<130.0.0.2, 224.0.1.39> EntryExpires: 100
RPF Route: 130.0.0.0/255.0.0.0 IIF: 107.0.8.4 UpNbr: 107.0.4.8
Pruned Oifs:
Address: 108.0.8.5 IfId: 95
Pruned due to assert
Pruned time remaining 130
<121.0.0.1, 224.0.1.40> EntryExpires: 102
Copyright © 2010, Juniper Networks, Inc.112
JunosE 11.2.x Multicast Routing Configuration Guide