• Example 3—On a router that is not a candidate BSR
host1:1#show ip pim bsr
This PIM router is not a Candidate BSR.
Elected BSR is 101.0.0.1 (priority 0), expires in 73 seconds.
• See show ip pim bsr.
show ip pim data-mdt
• Use to display information about active data MDTs.
• To display information about data MDTs on which the provider edge transmits data,
use the sender keyword.
• To display information about data MDTs on which the provider edge receives data,
use the receiver keyword.
• To display information about an IP PIM group address pool, use the group keyword.
• To display a summary of configuration for each data MDT, use the summary keyword.
• To display the number of data MDTs, use the count keyword.
• Field descriptions
• PE Name—Name of the PE
• C-SG—Address of the C-SG
• P-SG—Address of the P-SG
• MTI—Name of the dynamic IP tunnel on which the data MDT was created
• Data rate/Threshold—Rate and threshold of multicast data
• Time until next MDT Join TLV—Configured delay until next MDT Join TLV
• Time until MDT Join TLV expires—Configured delay until MDT Join TLV expires
• Time until switchover from default-MDT—Configured delay until the data MDT
switches over to the default MDT
• Example 1—Displays information about a data MDT sender
host1:PE1#show ip pim data-mdt 225.1.1.1
PE11 - Sender
C-SG: 10.11.0.100, 225.1.1.1
P-SG: 1.1.1.1, 235.0.1.1
MTI: TUNNEL gre:mvpn-dynamic-1
Data rate/Threshold: 10012/500 Kbps
Time until next MDT Join TLV: 25 seconds
• Example 2—Displays information about a data MDT receiver
host1:PE1#show ip pim data-mdt 225.2.2.2
PE31 - Receiver
C-SG: 10.13.0.100, 225.2.2.2
P-SG: 3.3.3.3, 235.0.1.1
MTI: TUNNEL gre:mvpn-dynamic-3
Time until MDT Join TLV expires: 29 seconds
111Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Configuring PIM for IPv4 Multicast
To Next Page
Loading...
Need help?
General
