<118.1.33.35, 232.0.0.1>
SSM Group
RPF Route: 118.1.0.0/255.255.0.0 IIF: 118.1.0.1 (Directly attached)
Oifs:
Register Oif to RP: 141.0.0.2 suppressed for SSM Group.
Address: 134.0.0.1 Interface: ATM3/0.104
Joined as <S, G> Join Expires: 161
<10.0.1.8, 235.1.1.1> EntryExpires: 143
Group-to-RP mapping: 224.0.0.0/240.0.0.0 RP: 123.0.0.1
RPF Route: 10.0.0.0/255.0.0.0 IIF: 106.0.7.3 UpNbr: 106.0.3.7
Oifs:
Address: 78.7.7.7 Interface: loopback7
Joined as <*, G>
Count of entries - <S, G> : 3
<*, G> : 3
<*, *, RP>: 0
• See show ip pim sparse-mode sg-state.
show ip pim sparse-mode unicast-route
• Use to display the unicast routes that PIM sparse mode is using.
• Field descriptions
• Route—IP address and network mask for the unicast route
• RpfNbr—RPF neighbor
• Iif—Incoming interface for the unicast route
• Pref—Preference value for the unicast route
• Metric—Value of metric for the unicast route (type of metric varies with the unicast
protocol)
• Count of entries—Number of unicast routes that PIM sparse mode is using
• Example
host1:2#show ip pim sparse-mode unicast-route
PIM SM unicast route table information
Route RpfNbr Iif Pref Metric
---------------------------------------------------------------------------
122.0.0.0 /255.0.0.0 122.0.0.1 255 1
Count of entries: 1
• See show ip pim sparse-mode unicast-route
show ip pim spt-threshold
• Use to display the threshold for switching to the shortest path tree at a PIM designated
router.
• Field descriptions
• Access List Name—Name of the IP access list that specifies the groups to which the
threshold applies
Copyright © 2010, Juniper Networks, Inc.118
JunosE 11.2.x Multicast Routing Configuration Guide
To Next Page
Loading...