Juniper JUNOSE 11.2.X MULTICAST ROUTING - Page 221

ff0e::70 fe80::90:1a02:1640:91 stop 3 FastEthernet2/4
40::10 01:10
40::11 01.24
ff0e::80 2/0 stop 3T FastEthernet2/5
50::10
fe80::90:1a02:1650:910 02:48
50::11
fe80::90:1a02:1650:920 02:56
fe80::90:1a02:1650:910 02:48
50::12 fe80::90:1a02:1650:920 02:56
ff0e::90 0/3 02:56 2T FastEthernet2/6
*
fe80::90:1a02:1660:910 02:48
fe80::90:1a02:1660:920 02:56
fe80::90:1a02:1660:930 02:48
• See show ipv6 mld membership.
show ipv6 mld oif-mapping
• Use to display the mapped OIF to be assigned to a given map-name, group address,
and source address.
• Field descriptions
• OIF-MAP Name—Name of the map requested
• Group Address—Multicast group IP address requested
• Source Address—Source IP address requested
• Mapped OIF—Join interface associated with the OIF map
• Example
host1#show ipv6 mld oif-mapping OIFMAP ff3e::1 10::10
OIF Mapping
OIF-MAP Name : OIFMAP
Group Address : ff3e::1
Source Address : 10::10
Mapped OIF : ATM5/0.120
• See show ipv6 mld oif-mapping.
show ipv6 mld ssm-mapping
• Use to display the SSM mapping state and the source list mapping associated with a
multicast group address.
• Field descriptions
• SSM Mapping—Status of SSM mapping on the interface (enabled or disabled)
• Group Address—Multicast group address requested
• Source List—List of sources mapped to the multicast group address
• Example
host1:boston#show ipv6 mld ssm-mapping ff3e::1
SSM Mapping : Enabled
199Copyright © 2010, Juniper Networks, Inc.
Chapter 6: Configuring Multicast Listener Discovery