ipv6 pim rp-address....................................................213
ipv6 pim rp-candidate................................................214
ipv6 pim spt-threshold...............................................216
See also show ipv6 pim commands
J
join messages.................................................................81, 208
L
leave group membership messages.......................42, 176
leaving an IP multicast group.............................................42
leaving an IPv6 multicast group.......................................176
limiting IGMP groups on interfaces..................................53
limiting MLD groups on interfaces..................................186
liveness detection
RIP and BFD.........................................................104, 220
M
M-BONE (multicast backbone of the Internet)..........121
manuals
comments on..................................................................xxi
MDT (Multicast Distribution Tree)
creating with default MDT..........................................92
mdt commands
mdt-data-delay.............................................................101
mdt-data-holddown...................................................101
mdt-data-timeout.......................................................102
mdt-interval...................................................................102
metric
DVMRP..............................................................................127
MLD (Multicast Listener Discovery)...............................175
configuring......................................................................180
disabling..........................................................................190
enabling..................................................................179, 180
limiting groups on interfaces...................................186
monitoring......................................................................190
performing host functions........................................201
removing.........................................................................190
specifying version...............................................160, 180
mld disable command........................................................190
MLD proxy...............................................................................200
configuring......................................................................201
enabling...........................................................................201
monitoring......................................................................203
version.............................................................................200
mrinfo requests, support for...............................................30
mtrace command...................................................................39
multicast
IP. See IP multicasting
IPv6. See IPv6 multicast
Multicast Distribution Tree. See MDT
multicast group port limit command.....................54, 187
Multicast Listener Discovery. See MLD
multicast VPNs
creating with data MDTs.............................................93
creating with the default MDT..................................92
overview.............................................................................92
N
neighbors, DVMRP................................................................122
notice icons...............................................................................xix
P
PIM (Protocol Independent Multicast)..................77, 222
displaying events.................................................107, 222
enabling
on a virtual router..........................................85, 211
on an interface..............................................86, 212
monitoring......................................................30, 107, 222
removing.................................................................106, 221
resetting counters and mappings................106, 222
using with DVMRP................................................86, 125
using with IGMP.............................................................86
using with MLD..............................................................212
See also PIM dense mode, PIM sparse mode,
PIM sparse-dense mode
PIM dense mode.....................................................................78
See also PIM
pim disable command..................................................85, 211
PIM SM. See PIM sparse mode
PIM sparse mode.........................................................80, 208
configuring auto-RP router........................................88
joining groups...............................................................208
pruning............................................................................208
remote neighbors, configuring.........................92, 216
setting a threshold................................................92, 216
timers.......................................................................82, 208
PIM sparse-dense mode ......................................................77
configuring auto-RP router........................................88
overview............................................................................83
PIM SSM (PIM source-specific multicast)
enabling..................................................................103, 219
requirements for IGMPv3..........................................103
requirements for MLDv2............................................219
Protocol Independent Multicast. See PIM
prune messages............................................................79, 208
Copyright © 2010, Juniper Networks, Inc.238
JunosE 11.2.x Multicast Routing Configuration Guide
To Next Page
Loading...
Need help?
General
