• Outgoing interface list—List of outgoing interfaces on the router. Details include:
• Type of interface and its specifier
• Action that the interface takes with packets: Forward or Blocked (port-limit)
• Protocol running on the interface: PIM, DVMRP, or IGMP
• Amount of time that the interface has been active in this multicast forwarding
entry, in days hours:minutes:seconds format
• Length of time that the interface can remain active in this multicast forwarding
entry, in days hours:minutes:seconds format or never
• Counts—Number of types of source group mappings
• (S, G)—Number of (S, G) entries
• (*, G)—Number of (*, G) entries
• Example 1—Constant bandwidth bit rate
host1#show ip mroute
IP Multicast Routing Table
(S, G) uptime d h:m:s
[Data rate: Kbps] [SPT Threshold: Kbps] [Threshold: Kbps]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10.0.10.1, 225.1.1.1) uptime 0 00:10:31
Data rate: 2132 Kbps, Threshold 500 Kbps
Admission bandwidth: 2000000 bps
RPF route: 10.0.10.0/24, incoming interface atm5/3.1010
neighbor 10.0.10.8, owner Local
Incoming interface list:
atm5/3.1010 (10.0.10.8/24), Accept/Pim (RPF IIF)
Outgoing interface list:
atm5/1.108 (108.0.8.5/8), Forward/Pim, 0 00:02:52/never
atm5/1.109 (107.0.8.4/8), Forward/Pim, 0 00:10:07/never
(1.1.1.1, 225.1.1.1) uptime 0 00:00:34, never expires
RPF route: 1.0.0.0/8, incoming interface ATM5/1.200
neighbor 2.2.2.2, owner Netmgmt
Incoming interface list:
ATM5/1.200 (2.1.1.1/8), Accept/Igmp (RPF IIF)
Outgoing interface list:
ATM5/1.300 (3.1.1.1/8), Forward/Igmp, 0 00:00:34/never
Counts: 2 (S, G) entries
0 (*, G) entries
31Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring IPv4 Multicast
To Next Page
Loading...
Need help?
General
