NOTE: The (S,G) entry (1.1.1.1, 225.1.1.1) is the permanent mroute.
• Example 2—Adaptive bandwidths enabled
Host1#show ip mroute
IP Multicast Routing Table
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10.0.1.9, 225.1.1.1) uptime 0 00:00:23
Admission bandwidth: 1998000 bps (adaptive)
QoS bandwidth: 1998000 bps (adaptive)
RPF route: 10.0.0.0/8, incoming interface ATM2/1.200
neighbor 21.1.1.1, owner Netmgmt
Incoming interface list:
ATM2/1.200 (21.2.2.2/8), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/1.300 (31.2.2.2/8), Blocked (port-adm-limit)/Pim, 0
00:00:23/never
Counts: 1 (S, G) entries
0 (*, G) entries
• See show ip mroute.
show ip mroute active
• Use to display the active multicast routes with admission bandwidth greater than the
specified bandwidth threshold.
• The default is 4000 bps.
• Field descriptions
• See the show ip mroute command and the show ip mroute summary command
for descriptions of all fields.
• Example 1—Displays active multicast routes with bandwidth above 10000 bps
host1#show ip mroute active 10000
Active IP Multicast Routes >=10000 bps
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
Copyright © 2010, Juniper Networks, Inc.32
JunosE 11.2.x Multicast Routing Configuration Guide
To Next Page
Loading...