Juniper JUNOSE 11.2.X MULTICAST ROUTING

QoS Adjust 2000000 bps
Active <S,G> count 15
Blocked <S,G> count 10
ATM2/0.132 (13.0.0.2/24) local Igmp owner Igmp
Admission-bandwidth 0/10000000 bps
QoS Adjust 0 bps
Active <S,G> count 25
Blocked <S,G> count 10
ATM2/0.133 (13.0.0.3/24) local Igmp owner Igmp
Admission-bandwidth 8000000/10000000 bps
QoS Adjust 0 bps
...
Count: 2 protocols
• See show ip multicast protocols.
show ip multicast protocols brief
• Use to display a summary of information about multicast protocols enabled on the
router.
• Field descriptions
• Protocol—Name of the multicast protocol
• Registered Interfaces—Number of interfaces on which the protocol is configured
• Owned Interfaces—Number of interfaces that a protocol owns. If you configure only
IGMP on an interface, IGMP owns the interface. However, if you configure IGMP and
either PIM or DVMRP on the same interface, PIM or DVMRP owns the interface.
• Type—Mode of the multicast protocol
• For DVMRP—Dense
• For PIM—Sparse, dense, or sparse-dense
• For IGMP—Local
• Count—Number of multicast protocols on the VR
• Example
host1#show ip multicast protocols brief
Protocol Registered Owned Type
Interfaces Interfaces
--------- ---------- ---------- -------------------
Pim 2 2 Sparse Dense
Igmp 1 0 Local
Count: 2 protocols
• See show ip multicast protocols.
show ip multicast routing
Use to display information about the status of IP multicast on the VR.•
37Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring IPv4 Multicast