0 excluded
Source-groups: 6 included, 0 excluded
• See show ip igmp groups.
show ip igmp interface
• Use to display IGMP information for interfaces on which you enabled IGMP.
• Specify the brief keyword to see a summary of the information.
• Specify the count keyword to see the number of IGMP interfaces.
• Specify the group address keyword to see information for interfaces that belong to
that group.
• Field descriptions
• Interface—Type of interface and interface specifier. For details about interface types
and specifiers, see Interface Types and Specifiers in JunosE Command Reference
Guide.
• address—IP address of the interface
• Administrative state—Status of the interface in the software: enabled or disabled
• Operational state—Physical status of the interface: enabled or disabled
• Version—IGMP version
• State—Function of the interface: querier or nonquerier
• Query Interval—Time interval in seconds at which this interface sends query messages
• Other querier present interval—Time in seconds that the interface waits before
declaring itself as the querier
• Maximum response time—Time interval, in tenths of a second, during which this
interface waits for a host to respond
• Last member query interval—Time, in tenths of a second, that this interface waits
before sending a new query to a host that sends a group leave message
• Robustness—Number of times this interface sends IGMP messages
• Information about whether the interface accepts IGMP reports from hosts on any
subnetwork
• Interface defaults to global promiscuous mode—Interface uses the setting of the
igmp promiscuous command to determine whether it accepts IGMP reports from
hosts on any subnetwork
• Information about standard IP access lists configured with the ip igmp access-group
command
• Inbound access group—Access list specified
• No inbound access group—No access list specified
Copyright © 2010, Juniper Networks, Inc.62
JunosE 11.2.x Multicast Routing Configuration Guide
To Next Page
Loading...
Need help?
General
