• Information about IP access lists configured with the ip igmp access-source-group
command
• Inbound access source-group—Access list specified
• No inbound access source-group—No access list specified
• Information about OIF maps configured with the ip igmp apply-oif-map command
• Inbound apply-oif-map—Map name specified
• No inbound apply-oif-map—No map name specified
• Immediate Leave—Setting of the ip igmp immediate-leave command: enabled or
disabled
• Explicit Host Tracking—Setting of the ip igmp explicit-tracking command: enabled
or disabled
• Max-Group limit—Number of IGMP groups that the interface can accept, as configured
with the ip igmp group limit command
• Admission-Bandwidth limit—Value of the admission-bandwidth limit set for an
interface that accepts IGMP groups, or No Limit
• Group Count—Number of IGMP groups that the interface has accepted
• IOA packet replication—Hardware multicast packet replication interface to which
egress multicast packets on this interface are redirected
• Interface statistics Rcvd—Information about IGMP messages received on this interface
• reports—Number of group membership reports received
• leaves—Number of group leave messages received
• wrong version queries—Number of group membership queries received from devices
running a different version of IGMP
• Interface statistics Sent—Number of IGMP messages this interface has sent
• Interface statistics Groups learned—Number of groups this interface has discovered
• Counts—Breakdown of IGMP interfaces
• down—Number of interfaces down
• init state—Number of interfaces in the initialization state
• querier—Number of querier interfaces
• non-querier—Number of non-querier interfaces
• Total—Total number of IGMP interfaces
• Example 1
63Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Configuring IGMP
To Next Page