Juniper QFX3500 - Page 135

To Next Page

To Previous Page

NOTE: You must complete this step if your Virtual Chassis includes a

combination of different types of switches, except when you are

configuring a Virtual Chassis that includes only QFX3500 and QFX3600

switches or only QFX5110 and QFX5100 switches (which are considered

to be non-mixed Virtual Chassis). See Understanding Mixed EX Series and

QFX Series Virtual Chassis or Virtual Chassis Fabric for details.

user@device> request virtual-chassis mode mixed reboot

3. After the master switch reboots, specify the identification parameters for the switch

by completing the initial configuration. See “Configuring a QFX3500 Device as a

Standalone Switch” on page 105, Configuring a QFX3600 Device as a Standalone Switch,

Configuring a QFX5100 Device, or Configuring a QFX5110 for details.

NOTE: The properties that you specify for the master switch apply to the

entire Virtual Chassis configuration.

4. (Optional) Configure the master switch with the virtual management Ethernet (VME)

interface for out-of-band management of the Virtual Chassis:

user@switch# set interfaces vme unit 0 family inet address /ip-address/mask/

5. (Optional) Configure mastership priority for the other member switches:

[edit virtual-chassis]

user@switch# set member 0 mastership-priority 255

user@switch# set member 1 mastership-priority 255

6. (Optional. Recommended for a two-member Virtual Chassis) On the master switch,

disable the split and merge feature:

[edit virtual-chassis]

user@switch# set no-split-detection

7. Power on the other member switches.

8. (Required for a mixed Virtual Chassis only) Set each individual switch into mixed

mode and reboot the switch to complete the configuration: