Juniper QFX3500 - Chapter 8 Pinout Specifications; Pinout Specifications; USB Port Specifications for the QFX Series

CHAPTER 8
Pinout Specifications
•
USB Port Specifications for the QFX Series on page 69
•
Console Port Connector Pinout Information on page 70
•
RJ-45 Management Port Connector Pinout Information on page 71
USB Port Specifications for the QFX Series
The following Juniper Networks USB flash drives have been tested and are officially
supported for the USB port in the QFX Series:
•
RE-USB-1G-S—1-gigabyte (GB) USB flash drive (except QFX3100 Director device)
•
RE-USB-2G-S—2-GB USB flash drive (except QFX3100 Director device)
•
RE-USB-4G-S—4-GB USB flash drive
CAUTION: Any USB memory product not listed as supported for the QFX
Series has not been tested by Juniper Networks. The use of any unsupported
USB memory product could expose your device to unpredictable behavior.
Juniper Networks TechnicalAssistance Center (JTAC) canprovide onlylimited
support forissues related tounsupportedhardware. We stronglyrecommend
that you use only supported USB flash drives.
CAUTION: Remove the USB flash drive before upgrading Junos OS or
rebooting a QFX Series device. Failure to do so could expose your device to
unpredictable behavior.
NOTE: Executing the request system snapshot CLI command on a QFX3500
device requires an external USB flash drive with at least 4 GB of free space.
We recommend using the RE-USB-4G-S flash drive.
69Copyright © 2017, Juniper Networks, Inc.