Figure 32: Slide Mounting Rail onto the Rear Mounting Blade
8. Align the holes in the mounting brackets with the holes in the rack. Ensure that the
chassis is level.
9. With four front mounting screws–and cage nuts and washers if your rack requires
them–attach the mounting bracket to the rack. Insert the first screw on the opposite
corner from the mounting blade. Tighten the screws.
10. Ensure that the switch chassis is level by verifying that the screws on the front of the
rack are aligned with the screws at the back of the rack.
11. With two mounting screws—and cage nuts and washers if your rack requires
them—slide the secondrear mounting blade into the blade receptacle on the mounting
blade, and secure it to the rear of the rack by tightening the screws. You might need
to loosen and adjust the other mounting blade to install the second blade.
Related
Documentation
• Rack-Mounting and Cabinet-Mounting Warnings on page 180
• Connecting AC Power to a QFX3500, QFX3600, or QFX3600-I Device on page 85
• Configuring a QFX3500 Device as a Standalone Switch on page 105
81Copyright © 2017, Juniper Networks, Inc.
Chapter 9: Unpacking and Mounting the Device
To Next Page
Loading...
