Juniper QFX3500 - Chapter 9 Unpacking and Mounting the Device; Unpacking and Mounting the Device; Installing and Connecting a QFX3500 Device

CHAPTER 9
Unpacking and Mounting the Device
•
Installing and Connecting a QFX3500 Device on page 75
•
Unpacking a QFX3500 Device on page 76
•
Mounting a QFX3500 Device in a Rack or Cabinet on page 77
Installing and Connecting a QFX3500 Device
To install and connect a QFX3500 device:
1. Follow the instructions in “Unpacking a QFX3500 Device” on page 76.
2. Mount the device by following the instructions in “Mounting a QFX3500 Device in a
Rack or Cabinet” on page 77.
3. Follow the instructions in “Connecting Earth Ground to a QFX3500 Device” on page 84.
4. Follow the instructions in “Connecting AC Power to a QFX3500, QFX3600, or
QFX3600-I Device” on page 85.
5. Depending on how you will be using the QFX3500 device, do one of the following:
•
If you are using the QFX3500 device as a standalone switch, follow the instructions
in “Configuring a QFX3500 Device as a Standalone Switch” on page 105.
•
If you are using the QFX3500 device as a Node device in a QFX3000-G QFabric
system, see QFX3000-G QFabric System Installation Overview forinformationabout
the steps to install and configure your QFX3000-G QFabric system.
•
If you are using the QFX3500 device as a Node device in a QFX3000-M QFabric
system, see QFX3000-M QFabric System Installation Overview for information about
the steps to install and configure your QFX3000-M QFabric system.
Related
Documentation
Rack Requirements for a QFX3500 Device on page 51•
• Cabinet Requirements for a QFX3500 Device on page 52
• Clearance Requirements for Airflow and Hardware Maintenance for a QFX3500 Device
on page 53
75Copyright © 2017, Juniper Networks, Inc.