CHAPTER 14
Replacing Transceivers and Fiber-Optic
Cables
•
Installing a Transceiver on page 133
•
Removing a Transceiver on page 135
•
Connecting a Fiber-Optic Cable on page 138
•
Disconnecting a Fiber-Optic Cable from a Device on page 139
•
Maintaining Fiber-Optic Cables on page 140
Installing a Transceiver
The transceivers for Juniper Networks devices are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the device or disrupting the device functions.
NOTE: After you insert a transceiver or after you change the media-type
configuration, wait for 6 seconds for the interface to display operational
commands.
NOTE: We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommendthat you check the third-party opticor cableand potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
133Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
