Juniper QFX3500 - Ramp Warning; Rack-Mounting and Cabinet-Mounting Warnings

säkerhetsanordning, och kontrolleras av den auktoritet som ansvarar för
området.
Related
Documentation
General Safety Guidelines and Warnings on page 169•
• General Electrical Safety Guidelines and Warnings on page 197
• Installation Instructions Warning on page 177
• Grounded Equipment Warning on page 184
Ramp Warning
WARNING: When installing the device, do not use a ramp inclined at more
than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytäsellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
Related
Documentation
General Safety Guidelines and Warnings on page 169•
• Installation Instructions Warning on page 177
• Grounded Equipment Warning on page 184
Rack-Mounting and Cabinet-Mounting Warnings
Ensure that the rack or cabinet in which the device is installed is evenly and securely
supported. Uneven mechanical loading could lead to a hazardous condition.
Copyright © 2017, Juniper Networks, Inc.180
QFX3500 Device Hardware Documentation