7. Remove the emergency boot device when prompted and then press Enter. The device
then reboots from the internal flash storage on which the software was just installed.
When the reboot is complete, the device displays the login prompt.
8. Create a new configuration as you did when the device was shipped from the factory,
or restore the previously saved configuration file to the device.
Release History Table DescriptionRelease
Starting in Junos OS Release 14.1, you can also use a system snapshot as a
bootup option when your Junos OS or configuration is damaged.
14.1
Related
Documentation
• Creating an Emergency Boot Device on page 161
165Copyright © 2017, Juniper Networks, Inc.
Chapter 18: Restoring Junos OS
To Next Page
Loading...
