EasyManuals Logo

Juniper SRX220 Hardware Guide

Juniper SRX220
182 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #151 background imageLoading...
Page #151 background image
CHAPTER 21
Fire Safety Requirements
•
SRX220 Services Gateway Fire Safety Requirements on page 133
SRX220 Services Gateway Fire Safety Requirements
In the event of a fire emergency involving devices and other network equipment, the
safety of people is the primary concern. Establish procedures for protecting people in
the event of a fire emergency, provide safety training, and properly provision fire-control
equipment and fire extinguishers.
In addition, establish procedures to protect your equipment in the event of a fire
emergency. Juniper Networks products should be installed in an environment suitable
for electronic equipment. We recommend that fire suppression equipment be available
in the event of a fire in the vicinity of the equipment and that all local fire, safety, and
electrical codes and ordinances be observed when installing and operating your
equipment.
In the event of an electrical hazard or an electrical fire, first turn power off to the equipment
at the source. Then use a Type C fire extinguisher to extinguish the fire. Type C fire
extinguishers, which use noncorrosive fire retardants such as carbon dioxide (CO
2
) and
Halotron, are most effective for suppressing electrical fires. Type C fire extinguishers
displace the oxygen from the point of combustion to eliminate the fire. For extinguishing
fire on or around equipment that draws air from the environment for cooling, use this
type of inert oxygen displacement extinguisher instead of an extinguisher that leaves
residue on equipment.
Do not use multipurpose Type ABC chemical fire extinguishers (dry chemical fire
extinguishers) near Juniper Networks equipment. The primary ingredient in these fire
extinguishers is monoammonium phosphate, which is very sticky and difficult to clean.
In addition, in minute amounts of moisture, monoammonium phosphate can become
highly corrosive and corrodes most metals.
Any equipment in a room in which a chemical fire extinguisher has been discharged is
subject to premature failure and unreliable operation. The equipment is considered to
be irreparably damaged.
133Copyright © 2016, Juniper Networks, Inc.

Table of Contents

Other manuals for Juniper SRX220

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX220 and is the answer not in the manual?

Juniper SRX220 Specifications

General IconGeneral
Product NameJuniper SRX220
CategoryGateway
Firewall Throughput750 Mbps
Maximum Concurrent Sessions64, 000
Memory1 GB DRAM
Flash Memory1 GB
Concurrent Sessions64, 000
Operating SystemJunos OS
Weight2.5 kg
Interfaces8 x 10/100/1000 Ethernet
Power SupplyAC 100-240V, 50-60Hz
Ports8 x 10/100/1000 Ethernet
Storage1 GB

Related product manuals