Table 26: SRX220 Services Gateway Preinstallation Checklist for
Rack-Mount Installation
Additional InformationTask
“Site Preparation Checklist for the SRX220
Services Gateway” on page 27
Verify that the site meets the requirements.
“SRX220 Services Gateway Rack
Requirements” on page 32
Verify that the racks or cabinets meet the specific
requirements.
“Clearance Requirements for Airflow and
Hardware Maintenance of the SRX220
Services Gateway” on page 33
Place the rack or cabinet in its permanent location,
allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
“Unpacking the SRX220 Services
Gateway” on page 49
Remove the services gateway chassis from the
shipping box.
Verify that you have the following parts available in
your rack-mounting kit for the SRX220 Services
Gateway:
•
Rack-mounting brackets
•
Screws
•
Power supply adapter tray with screws
NOTE: The rack-mounting kit is not shipped with the device and must be
ordered separately.
Related
Documentation
Clearance Requirements for Airflow and Hardware Maintenance of the SRX220 Services
Gateway on page 33
•
• Unpacking the SRX220 Services Gateway on page 49
• Verifying Parts Received with the SRX220 Services Gateway on page 49
• Preparing the SRX220 Services Gateway for Rack-Mount and Wall-Mount Installation
on page 53
• Preparing the SRX220 Services Gateway for Wall-Mount Installation on page 54
Preparing the SRX220 Services Gateway for Wall-Mount Installation
You can mount an SRX220 Services Gateway on a wall. The four rubber feet attached
to the chassis provide stability.
Table 27 on page 55 provides the list of tasks you need to perform before installing the
device on a wall.
Copyright © 2016, Juniper Networks, Inc.54
SRX220 Services Gateway Hardware Guide for H Model Numbers
To Next Page
Loading...
Need help?
General
