Resetting the SRX220 Services Gateway
The Reset Config button on the front panel of the services gateway can be used to remove
the current configuration and reset the device to the default (factory) configuration. The
button is recessed in the front panel to prevent it from being pressed accidentally.
NOTE: Pressing and holding the Reset Config button for 15 seconds or more
deletes all configurations on the device and loads and commits the default
(factory) configuration.
Related
Documentation
• Connecting the SRX220 Services Gateway to the Power Supply on page 73
• Grounding the SRX220 Services Gateway on page 66
• Using the Reset Config Button on the SRX220 Services Gateway on page 112
Copyright © 2016, Juniper Networks, Inc.76
SRX220 Services Gateway Hardware Guide for H Model Numbers
To Next Page
Loading...
