Juniper SRX220

CHAPTER 18
Troubleshooting Components
•
Monitoring the SRX220 Services Gateway Chassis Using the CLI on page 105
•
Monitoring the SRX220 Services Gateway Components Using LEDs on page 106
•
Monitoring the SRX220 Services Gateway Using Chassis Alarm Conditions on page 109
•
Monitoring the SRX220 Services Gateway Power System on page 110
•
Resetting the SRX220 Services Gateway on page 111
•
Using the Reset Config Button on the SRX220 Services Gateway on page 112
•
Changing the Reset Config Button Behavior on the SRX220 Services
Gateway on page 113
•
Juniper Networks Technical Assistance Center on page 113
Monitoring the SRX220 Services Gateway Chassis Using the CLI
You can monitor alarms to troubleshoot hardware problems on a services gateway. The
chassis properties include the status of active chassis alarms on the device, environmental
measurements, and the status of Mini-PIMs on the device.
To view these chassis properties, select Monitor in the J-Web interface, or enter the
following show commands on the command-line interface (CLI):
•
show chassis hardware
•
show chassis environment
•
show chassis fpc
•
show chassis alarms
Examples:
The following examples show sample output for CLI commands:
show chassis hardware
admin@host > show chassis hardware
Item Version Part number Serial number Description
Chassis SRX220-hm
Routing Engine REV X0 750-021778 000000PS2627 RE-SRX220-HIGHMEM
105Copyright © 2016, Juniper Networks, Inc.