CHAPTER 25
Electrical Safety Guidelines and Warnings
•
SRX220 Services Gateway Electrical Safety Guidelines and Warnings on page 151
SRX220 Services Gateway Electrical Safety Guidelines and Warnings
In Case of Electrical Accident
If an electrical accident results in an injury, take the following actions in this order:
1. Use caution. Be aware of potentially hazardous conditions that could cause further
injury.
2. Disconnect power from the services gateway.
3. If possible, send another person to get medical aid. Otherwise, assess the condition
of the victim, and then call for help.
General Electrical Safety Guidelines and Warnings
•
Install the services gateway in compliance with the following local, national, or
international electrical codes:
•
United States—National Fire Protection Association (NFPA 70), United States
National Electrical Code
•
Canada—Canadian Electrical Code, Part 1, CSA C22.1
•
Other countries—International Electromechanical Commission (IEC) 60364, Part 1
through Part 7
•
Evaluated to the TN power system
•
Locate the emergency power-off switch for the room in which you are working so that
if an electrical accident occurs, you can quickly turn off the power.
•
Do not work alone if potentially hazardous conditions exist anywhere in your workspace.
•
Never assume that power is disconnected from a circuit. Always check the circuit before
starting to work.
•
Carefully look for possible hazards in your work area, such as moist floors, ungrounded
power extension cords, and missing safety grounds.
151Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
