Juniper SRX220 Hardware Guide

Table 39: Component LEDs on the Services Gateway
Possible Causes and
Corrective ActionsMeaningStateLED
Normal condition. No action
is required.
The device is functioning
normally.
GreenStatus
Normal condition. No action
is required.
•
The device is starting up.
•
The Reset Config button
is pressed.
Amber
Contact the Juniper
Networks Technical
Assistance Center (JTAC).
See “Juniper Networks
Technical Assistance
Center” on page 113.
An error is detected in the
device.
Red
A major alarm indicates a
critical situation on the
gateway that requires
immediate action.
See “Monitoring the
SRX220 Services Gateway
Using Chassis Alarm
Conditions” on page 109.
The device detects a major
alarm.
RedAlarm
A minor alarm requires
monitoring or maintenance.
If left unchecked, it might
cause an interruption in
service or degradation in
performance.
See “Monitoring the
SRX220 Services Gateway
Using Chassis Alarm
Conditions” on page 109.
The device detects a minor
alarm.
Amber
Normal condition. No action
is required.
The device is starting up.
NOTE: If the system is up
and running and the Alarm
LED is off, it indicates that no
alarms are present on the
device.
Off
107Copyright © 2016, Juniper Networks, Inc.
Chapter 18: Troubleshooting Components

Juniper SRX220 Specifications

General

Product Name	Juniper SRX220
Category	Gateway
Firewall Throughput	750 Mbps
Maximum Concurrent Sessions	64, 000
Memory	1 GB DRAM
Flash Memory	1 GB
Concurrent Sessions	64, 000
Operating System	Junos OS
Weight	2.5 kg
Interfaces	8 x 10/100/1000 Ethernet
Power Supply	AC 100-240V, 50-60Hz
Ports	8 x 10/100/1000 Ethernet
Storage	1 GB